Gutter installation cost in NJ (2026)
Free NJ gutter cost estimate
A real ballpark range in under a minute — no email, no phone number, no sign-up.
Ballpark only — your real quote depends on exact linear feet, roof height, access, and material. Homeowners never pay us; we just match you with vetted local pros.
Cost by home size
| Home | Approx. gutter footage | Typical installed cost |
|---|---|---|
| 1-story ranch | ~150 ft | $1,100–$1,900 |
| 2-story colonial | ~200 ft | $1,600–$2,900 |
| Large 2–3 story | ~250–300 ft | $2,400–$4,500 |
| Estate / complex roofline | 300+ ft | $4,500–$11,000+ |
Cost by material
| Material | Per linear foot | Notes |
|---|---|---|
| Vinyl | $4–$8 | Cheapest; gets brittle in NJ winters |
| Aluminum (seamless) | $8–$15 | The NJ default — best value |
| Galvanized steel | $9–$18 | Stronger, but can rust |
| Copper | $25–$45 | 50–100 yr life; historic homes |
What drives the price up
Height — a 3-story job takes staging and more labor. Size — 6-inch gutters cost more per foot than 5-inch but handle far more water. Fascia repair — rotted board behind the old gutter is the most common change-order; budget $8–$15/ft if it's soft. Downspouts — usually $8–$12/ft, and more of them means better drainage. Tear-off — $1–$2/ft. Guards — add $1,800–$4,500 if bundled.
How to read a gutter bid
A real quote states: linear feet of gutter, gutter size (5" or 6"), material and gauge (.027 vs .032 aluminum — thicker is better), number and size of downspouts, hanger type and spacing, whether tear-off/disposal is included, fascia repair terms, and warranty on both material and labor. A one-line "gutters: $2,200" tells you nothing and hides everything.
Cheap bids that get expensive
Watch for: thin .027 aluminum quoted against a competitor's .032; spike-and-ferrule hangers instead of hidden hangers; tear-off excluded; too few downspouts (the runs will overflow no matter how good the gutter); and fascia repair left as "TBD."
Get 3 free installation quotes →
Replacement vs new installation
A replacement quote is almost always higher than a first-time install on the same house — and that gap is real work, not padding. Before the new gutters go up, the crew has to tear off the old ones, haul them away, and check the fascia board behind them. On older NJ homes that board is often soft where the old gutter trapped water, so it gets patched or replaced first. Budget an extra $1–$2 per linear foot for tear-off and disposal, plus $8–$15/ft anywhere the fascia needs work. A true first-time install — new construction, or a home that never had gutters — skips all of that, which is why identical footage can quote several hundred dollars less.
What the crew is actually doing. On a seamless job the installer feeds aluminum coil through a roll-former parked at your curb and cuts each gutter to the exact length of the run, so there are no mid-run seams to leak. They fasten hidden hangers into solid fascia every 18–24 inches, pitch each run slightly toward the downspouts, seal the corners and end caps, and tie the downspouts in to carry water away from the foundation. It's a one-day job on most single-family homes — the price covers fabrication, ladder-and-staging setup, and a crew that gets the pitch right, not just the metal itself.
Not sure how much gutter your house has? Ballpark it with our gutter cost by house size guide, then plug your footage into the gutter cost calculator before the quotes come in.
FAQ
How much does it cost to install gutters in NJ?
Most New Jersey single-family homes pay $1,400–$3,800 for new seamless aluminum gutters in 2026 — roughly $8–$15 per linear foot installed. Small ranches land near the bottom; large multi-story homes with copper or complex rooflines run well above it.
How much is gutter installation per foot?
Seamless aluminum runs about $8–$15 per linear foot installed in NJ. Steel is $9–$18, copper $25–$45, and vinyl $4–$8. Price per foot rises with roof height, gutter size, and access difficulty.
Does gutter installation include removing the old gutters?
Usually yes, but confirm it in writing. Tear-off and disposal typically adds $1–$2 per linear foot, and some low bids exclude it — which is a common way a cheap quote becomes an expensive surprise.
How long does gutter installation take?
Most single-family homes are done in one day. Seamless gutters are roll-formed on-site, so the crew fabricates and hangs runs the same visit. Complex or multi-story homes with fascia repair may take two.
How much do gutters cost per linear foot in NJ?
In NJ, seamless aluminum runs about $8–$15 per linear foot installed, galvanized steel $9–$18, and copper $25–$45. Multiply your rough gutter footage by that rate for a ballpark — a 200-foot house in aluminum lands around $1,600–$3,000 — then check the per-foot rate is spelled out on every quote so you can compare bids apples-to-apples.
Does replacing gutters cost more than a new install?
Usually, yes. A replacement adds tear-off and haul-away of the old gutters — typically $1–$2 per linear foot — plus fascia repair where the old system rotted the board behind it, at $8–$15/ft. A true first-time install on new construction skips that prep, so identical footage quotes lower. The seamless gutter itself is the same $8–$15/ft either way; the difference is the demolition and any wood repair underneath.
Related: Seamless vs sectional · 5" vs 6" gutters · Repair or replace?